Miranda RCP-100 Spezifikationen PDF herunterladen (Seite 8)

GUIDE TO INSTALLATION AND OPERATION

DNR-101i/111i |

2.2.3 imaging Solo Frame

To install this module into Solo follow these steps. For a closer look at module installation and

removal, refer to the frame's Guide to Installation and Operation.

1. In order to remove the frame's front panel, gently pull on it.

2. Carefully place the DNR-101i/111i between the module guides and gently push the module

towards the rear of the frame until the module's edge connector is secured to the backplane.

Pull lightly on the module verifying that it does not move.

Replace the frame's front panel.

2.3 Rear Panel Label

Several connector labels have been shipped with the DNR-101i/111i. A label is to be installed on the

frames’ rear panel in order to identify the module's external connectors.

To install the rear panel label on a Quartet, Quartet-C, Quartet-M, Quartet-M-A75, Quartet-M-A110

or a Solo frame, follow these steps while referring to Figure 2.1.

1. Locate the rear panel connectors associated with the DNR-101i/111i module.

2. Apply the label to the connectors and press down until it rests onto the BNC connectors

shoulder.

Figure 2.1 Quartet rear panel label installation

To install the Symphonie and Quartet 2 label, follow these steps while referring to Figure 2.2 (the

Quartet 2 uses the same rear panels as the Symphonie).

1. Locate the rear panel connectors associated with the DNR-101i/111i module. Find the

proper label according to your rear module type.

2. Apply the label to the connectors and press down until it rests onto the BNC connectors

shoulder.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 18 19

Keine Kommentare

Miranda RCP-100 Spezifikationen Seite 8