GUIDE TO INSTALLATION AND OPERATION
| DNR-101i/111i
6
3 Operation
The DNR-101i/111i can be controlled in three different ways:
• The card-edge push-buttons, 4-character display and status LEDs can be used to move through a menu
of parameters and to adjust parameter values.
• Miranda’s RCP-100 remote control panel can be used to access the same menu structure from a remote
location.
• Miranda’s iControl system can be used to access the card’s operating parameters from a remote
computer, using a convenient graphical user interface (GUI).
As the graphical interface is the most intuitive and easy-to-use method, it will be used as the basis for
describing the functionality of the DNR-101i/111i. Equivalent means of performing the same functions from
the menus are given in each case. A full description of how to use the card edge controls and the RCP-100
to access the menus is given in sections 3.2 and 3.3.
3.1 iControl Interface
iControl is Miranda’s graphical user interface. Users can remotely access and operate many Miranda
products from a remote computer via an IP interface.
Establish the IP connection to the computer and the frame containing the DNR-101i/111i card.
The iControl graphic interface window
The basic window structure for the DNR-101i/111i is shown in figure 3.1. The window identification line gives
the card type (DNR-101i/111i) and the card ID (116 in the example). The card ID identifies this specific card
to iControl, which may have access to multiple cards of the same type. The text in square brackets is the
Name given by the user to this card (which does not need to match the card type and ID as shown here); the
data entry point is accessed in the Info tab.
There are three main sections in the window itself:
1. The top section displays an icon on the left. This icon reports the status of the signal and its format:
Card status – green if OK, red and highlighted if an error has been detected
If the card status icon is RED indicating an error, an error status message will appear immediately below the
icon.
2. The middle portion of the window changes depending on which of the tabs is selected. Each of the four
panels is described in detail below.
3. The lower section of the window contains 2 buttons, one for recalling factory settings and the other for
saving the current configuration. In the event of a power down or card removal, this will allow the last
configuration to be loaded upon startup. Note that the current configuration is saved automatically after 30
seconds.
(33 Seiten)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Kommentare zu diesen Handbüchern