Miranda Kaleido-X Installationshandbuch PDF herunterladen (Seite 72)

Kaleido-X (14RU) Expansion

Expanding EXISTING Kaleido-X Frames

conditions (the Normal mode alarm should be green in all cases). Take note of the

Ethernet settings for each frame.

2 Power down both frames.

3 Check the pins on the expansion card connectors to make sure they are straight

(inserting a card with bent pins can damage the card).

4 Gently but firmly, slide one expansion card into the slot labelled OUTPUT D / EXP of the

Kaleido-X that will be designated Frame

5 Set the Frame ID switch on the rear panel to the Frame A position.

6 Gently but firmly, slide the other expansion card into the slot labelled OUTPUT D / EXP

of the Kaleido-X that will be designated Frame

7 Set the Frame ID switch on the rear panel to the Frame B position.

8 Connect the two expansion cards using the expansion cables:

•EXP LINK 1 on Frame A to EXP LINK 1 on Frame B

•EXP LINK 2 on Frame A to EXP LINK 2 on Frame B

Note: Be careful to install the KXO-EXP-R rear panel in the matching

location at the rear of the frame. The KXO-EXP-F card and its rear panel can

be installed in any order.

See Card Installation and Replacement on page 14

for more information.

IMPORTANT

Make sure that there is a KXO card in Slot C of Frame A.

This card will act as the master for the expansion frame. Another output card

may become the master.

Frame ID switch

1 2 ... 67 68 69 70 71 72 73 74 75 76 77 ... 96 97

Keine Kommentare

Miranda Kaleido-X Installationshandbuch Seite 72