Miranda Kaleido-X Installationshandbuch PDF herunterladen (Seite 58)

Kaleido-X (14RU) Expansion

Expanding NEW Kaleido-X Frames

Alarms may appear in the dashboard (see below), and, in some cases, you may see

blinking LEDs on the KXO cards in Frame

B. This is normal.

11 Wait 5 minutes (this allows some important internal processing to take place), and then

continue with the procedure

as described in Part B — XAdmin Settings below.

Frame B will not boot completely at this stage. This is normal.

Part B — XAdmin Settings

At this point, Frame A should be up and running, with all input, output, network and serial

cables in position, and Frame

B should not be rebooted.

Prior to expansion, each frame and all KXO cards normally have unique IP addresses. You

will use XAdmin to:

• specify one IP address for the expanded system;

• verify that there are no conflicts among the IP addresses of the KXO cards;

• make sure that all IP addresses are on the same subnet.

1 Open XAdmin for Frame A (refer to Opening XAdmin, in the Kaleido-X User’s Manual).

2 On the System Configuration page, select Enable expansion.

1.Even if, as in some cases, Frame B does not completely reboot.

Select the check

box to enable

expansion mode

Click here to

view this page

This button

becomes

available after

you click Save.

1 2 ... 53 54 55 56 57 58 59 60 61 62 63 ... 96 97

Keine Kommentare

Miranda Kaleido-X Installationshandbuch Seite 58