Miranda Kaleido-X Installationshandbuch PDF herunterladen (Seite 56)

Kaleido-X (14RU) Expansion

Installation

When two Kaleido-X frames are to be connected in an expansion configuration, it is

important to consider whether the frames are new, or have already been commissioned.

There are three possible combinations:

• NEW: two new Kaleido-X frames (see Expanding NEW Kaleido-X Frames, below).

• EXISTING: two previously commissioned Kaleido-X frames (see Expanding EXISTING

Kaleido-X Frames, on page 50).

• MIXED: one new Kaleido-X frame plus one previously commissioned frame (see

Expanding MIXED Kaleido-X Frames, on page 63).

Expanding NEW Kaleido-X Frames

Joining two NEW Kaleido-X frames in an expansion configuration involves the following:

• installing and interconnecting the expansion cards, and designating Frame A and

Frame B (see

Part A — Physical Setup below)

• configuring IP addresses for your expansion system (see Part B — XAdmin Settings, on

page 46)

• configuring your expansion system representation in XEdit (see Part C — XEdit

Settings, on page 48)

Part A — Physical Setup

1 Set up and configure the two standalone, independent Kaleido-X frames as described

in the Kaleido-X User’s Manual.

2 Open an XAdmin window for each frame. Click Status and options, and check the

frame and card status to make sure there are no problems or error conditions (the

Normal mode alarm should be green in all cases).

3 Power down both frames.

4 Check the pins on the expansion card connectors to make sure they are straight

(inserting a card with bent pins can damage the card).

IMPORTANT

You must follow the installation procedure that matches your situation.

Failure to do so may impair the proper functioning of your multiviewer

system.

IMPORTANT

All cards must be at Kaleido-X software version 3.00 (or later) before two

frames are joined in expansion mode.

To upgrade existing frames, follow the upgrade procedure described in the

Kaleido-X Version 4.10 (or later) Release Notes. Any spare cards you may

have can be upgraded via the Live Update feature by hot swapping them in

a standalone Kaleido-X at version 3.00 (or later). Check the card edge LEDs

to make sure the cards are operating normally.

1 2 ... 51 52 53 54 55 56 57 58 59 60 61 ... 96 97

Keine Kommentare

Miranda Kaleido-X Installationshandbuch Seite 56