Miranda RCP-200 Bedienerhandbuch PDF herunterladen (Seite 18)

GUIDE TO INSTALLATION AND OPERATION

14 | RCP-200

4. In the SELECT area, turn the left-most control knob to choose IP ADDRESS

5. Use the four control knobs in the CHANGE area to enter a new address.

• The starting address is displayed in the CURRENT data box for reference

• The new address you are entering is displayed in the MODIFIED databox, as well as at the controls

6. When done, push the SAVE control knob to store the value

• Note that if you select another IP element, e.g. GATEWAY, before saving, your changes will be discarded.

7. Repeat the process for NETWORK MASK and GATEWAY

8. Restart the RCP-200 by pushing the control knob below RESTART to apply the changes

• The panel will go dark for about 15 seconds before the startup screens appear

Specify Appservers for the RCP-200

The RCP-200 needs to connect to an appserver in order to control devices. The IP addresses of these appservers can

be entered manually.

• If the list of appservers is empty at startup, the RCP-200 will do multicast discovery until the next reboot.

When you have decided which appservers you will access, proceed as follows:

1. Press the CONFIG button, located between the two screens on the front of the RCP-200.

2. Touch the COMM category on the right-hand screen

3. Touch the DISCOVERY tab on the right-hand screen

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 48 49

Keine Kommentare

Miranda RCP-200 Bedienerhandbuch Seite 18